The difference between the structure of the bronzing machine and the bronzing machine

According to the following aspects, we can roughly distinguish the structural differences between the bronzing machine and the bronzing machine

Install the equipment that uses the bronzing paper and the bronzing machine and carries out the automatic transmission adjustment. Generally, the transmission of the bronzing machine has the time relay to adjust according to the time, the bronzing machine is apart from the time adjustment, and the photoelectric switch adjustment is carried out according to the node identification on the thermal transfer printing machine.

Worktable: worktable is used to store fixture and substrate. The worktable specifically includes plane worktable, shuttle worktable, turntable worktable, etc.

The flat work table is used on the flat ironing machine and the flat ironing machine, and the shuttle work table is used on the curved surface ironing machine and the curved surface ironing machine. In order to better improve the stamping efficiency, the rotary table work table can also be installed and used on the flat ironing machine.

The hot head of the bronzing machine is a silicon rubber roller which can be operated up and down and rotated

In the whole process of pressing, the head should be pressed down and kept in touch with the object for a period of time and then raised. And it is regulated by time relay.

The bronzing head of the bronzing machine is a flat hot plate, which is equipped with a heating plate, which can move up and down.

The upper and lower drive of the stamping machine is pushed by the air cylinder.

The control system is used to arrange the operation of the above mechanical equipment in order to make the whole printing process automatic. Today's bronzing machine and bronzing machine basically reach the microcomputer regulation, and the function is relatively stable, safe and reliable. The control keys of the operation panel are divided into two functions: trial operation and automatic operation. The former is used for adjusting the machine, and the latter is used for manufacturing